Frequently Asked Questions
How long does it take to set up the Aqua Jump?
It takes one to two hours to set up the Aqua Jump for the
first time, quicker if there are several people to help or if you’ve
done it before. This time can also be reduced significantly if the
trampoline surface is left assembled during storage and only the tube
needs to be inflated for subsequent set ups. On their spring-less
(Bongo™ and O-Zone™)
products, setup time is only a couple minutes. Without springs or
bars, the Bongo and O-Zone products simply require inflating the tube.
-----------------------------------------------------------------------------------------------------
How do you inflate the Aqua
Jump tube?
We highly recommend using an industrial inflator /
deflator like the RAVE Hurricane Blower.
With this blower, it only takes about 10 to 20 minutes to inflate
the Aqua Jump tube, depending on the tube size. You can order this
high volume inflator / deflator directly from Anchor Dock and Lift
by calling 320-274-6500. Using the air output side of a shop vacuum
is also an effective way of swiftly inflating the tube, since shop
vacuums typically have high air flow rates.
-----------------------------------------------------------------------------------------------------
Can I use an Air Compressor
to inflate the tube?
We do not recommend the use of an air compressor as
over inflation can damage the tube. RAVE’s commercial grade
products are fully inflated with only 1-2 PSI of air pressure. The
high pressure output of most air compressors can easily cause over
inflation if not monitored properly during the inflation process.
If a compressor is used, be sure not to exceed 2 PSI within the tube.
-----------------------------------------------------------------------------------------------------
How do you deflate the Aqua
Jump tube?
Again, you can use the RAVE
Sports Hurricane inflator / deflator or a shop vacuum, positioned
in reverse, to swiftly deflate the tube. Another option is to lock
the valve open on the tube and let the air naturally flow out of the
large opening of the valve.
-----------------------------------------------------------------------------------------------------
What is the tube made of?
The tube material is the same high-grade material used in many
ocean-going inflatables and inflatable military boats. It’s
a 1000 Denier Polyester with 28 oz. UV treated PVC. All seams are
heat-welded for maximum strength and doubled at key stress points.
We don not use natural rubber or natural rubber latex in any of our
products. Therefore, people with allergic reactions to latex should
not have any problems using our products.
-----------------------------------------------------------------------------------------------------
Can the Aqua Jump be used
in salt water?
Yes, the Aqua Jump can be used in the ocean and other salt
water locations. In addition to the UV-treated material, the Aqua
Jump’s springs, V-rings and tramp frame are made from heavy
gauge, hot dipped galvanized steel. Because of the salt-water environment,
springs may need to be replaced more frequently. Stainless steel components
are also used where practical.
-----------------------------------------------------------------------------------------------------
Will the Aqua Jump fade
in the sun?
The tube will retain its brilliance for years because UV inhibitors
are specially blended into the chemistry of our PVC materials. We
also recommend using 303 Aerospace
Protectant as a secondary topical agent (like sunscreen for your
skin) to prevent fading and degradation. 303 also restores lost color
and luster, making your Aqua Jump vinyl look like new. Periodic (monthly)
application of 303 protectant will provide the best results.
-----------------------------------------------------------------------------------------------------
Can the Aqua Jump be left
out in the water?
Most people leave their Aqua Jump in the water for the season.
There are two things to consider: 1) your local regulations regarding
anchoring and 2) if the area is consistently exposed to high winds.
In those parts of the world where the water never freezes, the Aqua
Jump can be left in all year.
-----------------------------------------------------------------------------------------------------
How deep does the water
need to be to use the Aqua Jump?
You should anchor your Aqua Jump in at least 10 feet of water
in an area at least 30 feet from any docks, boats or other obstructions.
-----------------------------------------------------------------------------------------------------
How do you anchor the Aqua
Jump?
Sufficient anchoring methods will vary depending on your local
conditions (ex. Water depth, type of water bottom, exposure to high
winds or water current, etc.). Please consult with local authorities
(ie. Dock and lift dealerships, marinas or your local water enforcement
officials) to understand proven anchoring methods or anchoring restrictions
in your area. A heavy duty harness is included with your Aqua Jump.
The anchoring method you select should attach to the swivel ring on
this harness.
Tips for Anchoring:
- We recommend using a shock cord as a part of the
anchor line to help absorb vertical movements of the Aqua Jump due
to waves and normal use. An Anchor
Connecting System is available directly from Anchor Dock and
Lift which includes this shock cord. Call 320-274-6500 for more
information.
- Choose a location most protected from wind and water
currents.
- A minimum of 60 lbs. of anchor weight is recommended
for most applications. However, Aqua Jumps on larger bodies of water
may require more.
- Bell anchors are not recommended since they are easily
dragged, especially on firm bottoms. Multiple foundation blocks
are commonly used on soft bottoms. Screw-type or more permanent
toggle-style anchors are typically used in more extreme conditions.
Recommendations for anchor line length can be found in your owner
manual.
-----------------------------------------------------------------------------------------------------
How do you transport the Aqua Jump on the land
and water?
You should enlist two or three people to help you lift and
carry the smaller Aqua Jumps from land to water, and four to five
people for the largest Aqua Jump. DO NOT DRAG. RAVE doesn’t
recommend towing the Aqua Jump on the water, although it can be transported
at very low speeds.
-----------------------------------------------------------------------------------------------------
Can the Aqua Jump be used
as a land trampoline?
The Aqua Jump was not designed for use on land. Like any inflatable
product, the Aqua Jump tube should not be exposed to rough edges or
sharp objects like rocks and sticks.
-----------------------------------------------------------------------------------------------------
How high can you bounce
on the Aqua Jump?
The bounce height depends on the firmness of tube
inflation and weight and strength of the bouncer. It won’t perform
exactly like a land trampoline because the water and inflated tube
absorb some of the bounce. The trampoline surface is designed so you
won’t hit the water below, even with really big bounces. Some
water may splash up, however, from the wave action caused by the tube.
-----------------------------------------------------------------------------------------------------
Do you need a permit for
the Aqua Jump?
Most areas do not require any special permits, however, you
should check with your local authorities or DNR to determine permit
requirements in your area.
-----------------------------------------------------------------------------------------------------
How do you repair the Aqua
Jump?
You can locate a leak in an inflated product by spraying the
tube with soapy water. When you find the leak and determine the hole
size, use a patch from the repair kit
and cut a swatch 1 inch wider than the hole. Deflate the product and
clean the area around the hole with rubbing alcohol. Apply glue from
the repair kit to the patch and the area around the hole. Let the
glue dry approximately 2 minutes until it becomes tacky. Stick the
glued parts to each other and rub them together using a hard, smooth,
flat surface. Let the patch dry for at least 24 hours before inflating.
For bigger holes and tears, follow the same procedure but put a patch
on the inside as well as the outside.
-----------------------------------------------------------------------------------------------------
What is the warranty on
the Aqua Jump?
RAVE offers a one-year warranty for defects in material
or workmanship. If the product is being used commercially, like at
a camp or resort, there is a 6-month warranty.
-----------------------------------------------------------------------------------------------------
How do you maintain and
store the Aqua Jump?
To store the Aqua Jump, you should first clean the
entire inflatable with soap and water or other mild cleansers. Do
not use petroleum based or vegetable oil based cleaners. After the
tube dries, deflate the tube. Roll the tube loosely and place in a
vented container. (A large plastic storage container (Rubbermaid or
a similar brand) works well to store the tube and keep safe from rodents).
Some people prefer to keep the trampoline frame intact and lean it
against a wall instead of taking all the pieces apart.
-----------------------------------------------------------------------------------------------------
How is the Aqua Jump different
from other water trampolines?
The Aqua Jump is the original water trampoline, manufactured
by RAVE Sports. We are experienced leaders in this industry and the
quality of the product shows it. The Aqua Jump is designed for the
rugged wear-and-tear use exhibited by camps and resorts and has:
- great accessories like the Aqua
Launch, Aqua Log and
Aqua Slide to enhance the
fun.
- All welded construction (No Glue!). Seams stay firmly
sealed even in the hottest sun.
- a Halkey-Roberts™ valve having a large orifice
diameter that allows you to easily inflate your tube. It’s
a commercial-grade valve that has a rotating open/close stem that’s
easy to use. One really convenient feature of the Aqua Jump is that
this valve is located on the tube above the water line, in case
you need to adjust the air while the tube is in the water.
- a stainless steel marine ladder shaped to the tube
contour.
- an extra-wide and extra thick spring pad cover to
protect the user from the frame and springs.
- multiple bar holder straps to stabilize the jump
surface, as well as frame sleeves to cover the frame connection
joints.
- a multi-point interior anchoring system that protects
jumpers from all anchor lines.
-----------------------------------------------------------------------------------------------------
With one chamber, will the Aqua Jump sink if
it gets a hole?
The Aqua Jump will not sink if the tube is punctured. Enough
air accumulates in the tube to keep the Aqua Jump components afloat.
A single air chamber also provides even distribution of the air around
the full perimeter of the product, even if air pressure gets low.
-----------------------------------------------------------------------------------------------------
Does Anchor Dock & Lift
sell covers for the Aqua Jumps?
Yes. Covers are available.
Please for more information visit our accessories page.
-----------------------------------------------------------------------------------------------------
What can I do to keep my
product safe from muskrats, mice and other rodents?
Rodents like muskrats may be attracted to the PVC vinyl of
our product. When your tube is on the water, maintaining full air
pressure during periods of non-use usually prevents them from being
able to get a hold of the vinyl to chew on it. However, the best way
to solve the problem of nuisance rodents is to remove the temptation
by taking the product out of the water at night. Another option is
to make the whole area unattractive to rodents by changing the environment,
eliminating food sources along the shoreline and making the area less
hospitable to their inhabitance.
<<< back to Water Toys &
Accessories